LED Dream-color Controller

Detailed Product Description

 

Summarization

RF Dream-color controller is designed for led production which use HL1606 as driver , it has 128*128*128 grayscale , Length setup funtion and Power-fail memory function, you could choose it freely in a lot of programs, meanwhile,you could adjust all kinds of dynamic lighting changes by RF remote controller.It is very useful for light box advertisement,stage light,house decorating and so on.

     

Technical parameters

working temperature:-20-60°C

supply voltage:DC12V 

external dimension:L94ΧW58ΧH26 mm

packing size:L145ΧW95ΧH50 mm

net weight:205 g

gross weight:235 g

rated power:2.2W

output: two SPI signals 

  

  

  

External Dimension

 

 

 

 

  

 

 

Interface Specification

          Power input interface:

 

 

  Adopt conventional DC power Transposon as power input interface.

                   

          

Load output interface:

 

 

 Adopt 5-pin Connector pin. 

 

  

Direction for use

1. Connect the load wire at first, following by the power wire; Please ensure short circuit can not  occur between connecting wire before you turn on the power.

 

   2.    There are eight buttons altogether on controller panel, and every button function as follows:

ON/OFF button,it can open or close led anytime,when led is on the state of closing,the LCD will display IC NUMBER: ***,  *** is the value of current setting.

Play/pause button,when you want to see the static effection of led ,you may press this button to pause.

Adding button,to add the IC NUMBER,the maximum is 255 (510 groups of RGB)

Reducing button,to reduce the IC NUMBER,the least number is 16 (32 groups of RGB);

Program choosing button,up direction,there are 83 programs in all.

Program choosing button,down direction;

Speed-down button,there are 100 steps in all;

Speed-up button.

 

  3.   There are six buttons altogether on remote controller panel, and every button function as follows:

   ON / OFF: you could turn on or off load output at any time;

   MODE: mode button, you can choose playing or pausing mode,and observe the static results of LED in the state of suspension mode .

   S +: the button to increase the rate of change;

   S-:  the button to slow down the rate of change, a total of 100 steps;

   B +: procedures for the selection key and up choice, a total of 83 procedures;

   B-:  procedures for the selection key, down choice.

 

    4.  The description of signal output interface: L, K ,D, S is the corresponding signal of HL1606,which is L_I,CK_I,D_I,S_I.

Program description:(Condition: A1-Blue LED;A2-Red LED;A3-Green LED)

 

5. Standard color changes as follows:

 

 

 

Typical Application